Getting it right on Corrugated board: Keep it clean!

By Apex International | Jul 22, 2019 9:44:06 AM

Flexo printers are facing many challenges every day, with the flexo printing process itself often being one of the biggest of them all. This is caused by the huge amount of variables involved. And printing on corrugated makes it even harder to achieve the required result. Keeping the flow of ink consistent is key to getting it right.

Read More >

6 guide lines to increase the lifetime of your anilox

By Apex International | May 23, 2019 8:00:00 AM

The anilox is considered to be the heart of the printing press. During the production process the tolerances are within micrometers. This counts for the body, the bearings, the journals and just as much for the ceramic layer on top and its laser engraving technology creating the volume. Once the roll or sleeve is delivered to you, we expect you to treat it with the utmost care as well in order to create the longest possible lifetime.

Read More >

Top causes of Dot Gain related to Anilox rolls

By Apex International | May 20, 2019 9:01:08 AM

Dot gain in flexographic printing has a variety of causes and shows up in enlarged halftone dots to derformed dots, which can print out fuzzy sometimes. There are several causes of dot gain that are related to anilox rolls, however, there are also solutions to overcome dot gain or decrease it. 

Read More >

Getting practical with anilox measurements - Complete process control is key to consistent print quality

By Apex International | Mar 18, 2019 10:10:00 AM

Labels and packaging producer Reflex is one of the largest companies of its kind in the UK: “We seek to be on the forefront of innovation, investing in technology and people for continuous improvement.” In an effort to standardize print quality at its label division, consisting of seven production sites with multiple presses, Reflex teamed up with Apex experts to aim for better process control.

Read More >

Getting real with Anilox Measurements - Aiming for constant control and consistency

By Apex International | Mar 7, 2019 10:09:00 AM

Both Apex and its customers need to measure aniloxes - but for different reasons! Control and consistency are the foundation for process standardization, ECG printing and  improved productivity in flexographic printing. The anilox surface – where ink meets plate – has always been the foundation for achieving high print quality on a repeatable basis “ideally” without constant process adjustments. Apex focused on this challenge and reinvented the basics of ink-to-plate transfer by creating the Patented GTT engraving. This advancement has resulted in a far more consistent anilox which is proven, both in print production at customers and internally with the microscopic measurement control possible from both Troika and MD control systems. These two systems validate that Apex aniloxes are produced globally with the highest level of accuracy.

Read More >
COMMENTS